Commands for Remote Management and Diagnostics
remote ap-cli <AP-MAC-Address> “AP CLI command”
Use remote ap-cli command to execute AP CLI commands remotely from SCG.
get scg
Use get scg to display SCG settings.
set scg ip “IP Address”
Use set scg ip to set the IP address of the control interface.
get director
Use get director to show ZoneDirector information.
set director ip “IP Address”
Use set director ip to set ZoneDirector options. A reboot is required for changes to take effect.
ping
Use the ping command to attempt to ping another station.
traceroute
Use the traceroute command to conduct a traceroute test.
get version
Use get version to display the software version running on the AP.
get uptime
Use get uptime to display how long the Ruckus Wireless device has been running.
sysinfo
Use sysinfo to get CPU and memory utilization information.
get ap-mode
Use get ap-mode to display AP operation mode (standalone or managed mode).
get boarddata
Use get boarddata to display hardware version and system board information.
support
Use support to generate support log information.
support show
Use support show to show support log information.
fw show all
Use fw show all to display firmware.
get tunnelmgr
Use get tunnelmgr command to display tunnelmgr settings.
get wlanlist
Use get wlanlist to display a list of all WLAN interfaces. If the AP is a dual-radio AP, the RadioID column indicates which radio (2.4GHz or 5GHz) is serving the WLAN.
get wlaninfo
Use get wlaninfo to list all configured WLAN interfaces and security settings.
get channel <wlan name>
Use get channel to display the transmit channel on the device.
get state <wlan name>
Use get state to display the state of a WLAN interface.
set state <wlan name> {up|down}
Use set state to configure the state of a WLAN interface.
get station <wlan name> list
Use get station to get station list, information, and statistics.
get mqstats <wlan name> all
Use get mqstats to display Media Queue Statistics.
get rpki-cert {issuer|subject|validity}
Use get rpki-cert to display AP certificate information.
reboot
Use reboot to restart the AP.
set factory
Use set factory to return all configuration settings to their factory defaults.
Commands for Remote Packet Capture
set capture wlan100 stream
This sets up packet capture on the 2.4GHz radio.
get capture wlan100 state
This displays the status of 2.4GHz radio capture.
set capture wlan100 idle
To stop the capture on the 2.4GHz radio.
set capture wlan101 stream
This sets up packet capture on the 5GHz radio.
get capture wlan101 state
This displays the status of 5GHz radio capture.
set capture wlan101 idle
To stop the capture on the 5GHz radio.